NT-LP110A Label Printer Setup Guide

Shopify Setup

Platform Setup

Follow these simple steps to setup your Shopify to Print to NT-LP110A. Click on Settings on the left side menu. Select Shipping under Settings. Set your Shipping Label Printing to “4 x 6 label printers (DYMO or similar). Click on “Print test label” to print a sample label. Alternatively, you may update your label settings when you are purchasing postage for your order.Please refer to the following screenshot for details

Saiba mais →


Why I printed many blank labels?

Printing Issue

A. The most common reason is that your labels are loaded in upside down. Please ensure your labels are properly loaded. The label that you peel off should be facing the ceiling when it comes out of the printer B. Ensure your labels are “Direct Thermal” labels. If you are not sure whether you are using direct thermal label paper, you can scrape or burn the surface of the label to check if it will becomes black. If there is no change, it means that it is not thermal label paper. , You need to replace the paper

Saiba mais →


Why are there some white spots in the printed labels?

Printing Issue

A. It is might be the printer head has gotten dirty.(1) Please turn off the printer and allow it to cool down (2) Please use the provided alcohol pads to wipe the printer head clean. Any 70% Isopropyl Alcohol pad would work. These are commonly available in pharmacies and grocery stores as well as on Amazon. Image below shows the highlighted areas that could cause this fade / dead zone. (3) Allow 2-3 minutes for components to dry, then turn it back on.Finally, it is possible that something has interfered with NT-LP110A’s driver. If you exclude above reason, please uninstall...

Saiba mais →


Why my labels are not sharp / dark?

Printing Issue

It may caused by following reasons; A. LabelThe darkness of the label depends on the quality of the label. High-quality labels will produce darker labelsB. Print density and speedIn the preferences of the printer “NT-LP110A”, you can lower the “Density” and “Speed” to increase the resolution.However, it should be noted that excessively increasing the concentration will cause unnecessary black lines or the label becomes too hot and sticky, and reducing the concentration will make the label shallower.C. Margin and page sizePlease make sure that the document content occupies the entire label. If there is an extra border, thelabel will be...

Saiba mais →